Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IRRIGATION ENGINEERING Report
#1

IRRIGATION ENGINEERING


.docx   canal.docx (Size: 17.86 KB / Downloads: 86)

Slide 2:

Chapter 2 Canal Irrigation Canal irrigation in is one of the principal methods used for improving the growth of the crops. After wells and tube wells, canal irrigation is the second most important irrigation source. However, this method is only extended to those areas that are large level plains of deep fertile soil and are drained by well distributed perennial rivers. Classification of canal:- Classification based on the type of soil alluvial canals Non alluvial canals Classification based on the nature of supply perennial or permanent canals Non- perennial or inundation canals Classification based on the funds available protective canals Productive canals Classification according to the nature of source of supply: Permanent canals: A canal is said to be permanent when its source of supply is sufficiently assured to warrant construction of protective and regulatory works with a regular, permanent and graded channel. Inundation canals: Supply of water to the canal depends upon periodical rise in the water level of a river from which the canal takes off. Construction of permanent regulatory work is very rarely done in this case.

Slide 3:

Canal Alignment: Irrigation water in flow type should reach the fields by gravity. To accomplish this requirement irrigation canal is always aligned in such a way that the water gets proper command over the whole irrigable area. Various types of canal alignments: Alignment of contour channels Alignment of ridge or watershed channels Alignment of side slope channels Points to be considered while aligning a canal It should be aligned on the ridge to get maximum benefits . As far as possible canal alignment should be kept in the centre of the commanded area. Length of canal should be as minimum as possible Alignment should avoid inhabited places, roads, railways, peoperties, places of worship etc. Canal should be taken through area where subsoil formation is favorable. Alignment should be straight as far as possible. Excessive cuttings and fillings should be avoided. While aligning canal cost of acquisition should be taken in mind. It should cross minimum no of drinages

Inundation Canals:

Inundation Canals This canal takes off directly from a canal. The canal is taken in the direction of general slope of the area. As no head work is provided supply of water to the canal wholly depends on the stage of the river. When there is a flood in the river, water level remains high, flood water flows in the canal from the river. This type of canal is in use during period of rainfall and subsequent runoff in the streams and rivers. Once the canal alignment is fixed the canal is excavated to accommodate anticipated quantity of water. Selection of site for takeoff: River reach from where inundation canal is to take off should be straight. As far as possible there should be a shoal in front of take off point. Presence of shoal creates a still pond in the pocket, thus silt entry in the canal is restricted. River bank should be high and stable at the site.

BANDHARA IRRIGATION SYSTEM:

BANDHARA IRRIGATION SYSTEM This is a type of flow irrigation system. Extensively used in some parts of Maharastra. This method consists in building a small barrier across a stream or a river to raise water level on the up stream of the barrier. Then the water is diverted in a canal through a head regulator for irrigation purposes. After raising the water level to a required level excess water flow over the barrier. Spilling water flows down which can be further checked by constructing another barrier . This type of system is suitable in places where there are number of small rivers and streams. Selection of site for Bhandhara: There should be sufficient supply of water at site. There should be a good foundation available at moderate depth in the bed of the river. The site should not be far away from the irrigable land. The banks of the river at the site should be high to avoid flooding. The section of the river at the site should be tight.

Advantages: :

Advantages: The area irrigated is small and close to source. Naturally the duty is high and irrigation is of intensive type. As the conveyance system is of small length losses in handling and conveyance of water are less. The cost of system is low. The small quantity of water flowing in river which would have gone waste, is used up to a maximum extent in this system. Disadvantages : If the stream or river is non perennial then the supply of water is uncertain. As even small portion of water is dammed, population below the site of bandhara do not get water supply for domestic uses in dry periods. Irrigable area for one bandhara is fixed and even if more quantity of water is available it is of no use in that system. Regime Channel : The channel which neither silting nor scouring takes place is called regime or stable channel.

Slide 7:

Design by Kennedy’s theory Kennedy, an executive engineer of Punjab PWD, did pioneering research for obtaining a stable non-silting, non- scouring irrigation canal system. On the basis of observations made in certain reaches of Upper Ban Doab Canal system in Punjab, which were found to be fairly stable, i.e., required no silt clearance for about three decades, Kennedy concluded that, 1. The flowing water is to counteract friction against the bed of the channel resulting in generation of vertical eddies rising up gently to the water surface and work up against the depth of channel. These eddies keep most of the silt in suspension. 2. The silt supporting power of a channel cross section is mainly dependent on these eddies. Some of the eddies may start from the sides of the channel but these are for most of their part horizontal and as such of no silt supporting power. The silt supporting power of the channel is, therefore, proportional to the bed width, 3. A velocity sufficient to generate these eddies keeps the sediment in suspension thereby avoiding silting up of the channel.

Suspended Load:

Suspended Load Sediment suspended and transported through the stream. Turbulent flow suspends clay and silt in the stream. Suspended load comes from material eroded from the surface bordering the channel and deposited in the stream, as well as, erosion of the channel itself.

Bed Load:

Bed Load Is moved across the bed of the channel. Bed load is transported in two ways, Traction, which is a scooting and rolling of particles along the bed. Saltation, which occurs when particles are suspended in the stream for a short distance after which they fall to the bed, dislodging particles from the bed. The dislodged particles move downstream a short distance where they fall to the bed, again dislodging particles upon impact.
Reply

Marked Categories : es seminar report on canal, irrigation engineering full seminar report, www a civil engg project seminar report on flow canal irrigation i, www a civil engg project seminar report on different part of canal irrigation and their function, civil engineering seminar topics on irrigation, www civil engineering project seminar report on canal irrigation, irrigation engineering question bank, topic on irrigation engineering, advantages and disadvantages excavated pond on irrigation purposes, seminar topics on irrigation engineering, project report on canal irrigation engineering, how to start a good engineering report, report on topic of irrigation engg, canal,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  CANAL IRRIGATION seminar paper 1 19,165 22-09-2017, 10:59 AM
Last Post: jaseela123
  AMAZING CIVIL ENGINEERING STRUCTURES PPT project girl 1 2,321 20-09-2017, 11:52 AM
Last Post: jaseela123
  Special concretes Report seminar projects maker 1 1,842 15-09-2017, 12:53 PM
Last Post: jaseela123
  COMPUTATIONAL MECHANICS IN ENGINEERING AND ITS APPLICATION seminar projects crazy 0 11,636,076 25-08-2017, 09:32 PM
Last Post: seminar projects crazy
  SOME PERSONAL VIEWS FROM A WORKING LIFE IN ENGINEERING AND HSE IN ENERGY INDUSTRIES super 0 12,777,921 25-08-2017, 09:32 PM
Last Post: super
  Application Of Infrared Thermography In Concrete Engineering computer science crazy 0 10,815,698 25-08-2017, 09:32 PM
Last Post: computer science crazy
  Civil Engineering seminar Abstract And Report 3 computer science crazy 0 16,204,412 25-08-2017, 09:32 PM
Last Post: computer science crazy
Lightbulb Civil Engineering seminar Abstract And Report 4 computer science crazy 0 16,484,591 25-08-2017, 09:32 PM
Last Post: computer science crazy
Lightbulb Civil Engineering seminar Abstract And Report computer science crazy 0 20,245,097 25-08-2017, 09:32 PM
Last Post: computer science crazy
  Civil Engineering seminar Abstract And Report computer science crazy 0 24,544,054 25-08-2017, 09:32 PM
Last Post: computer science crazy
This Page May Contain What is IRRIGATION ENGINEERING Report And Latest Information/News About IRRIGATION ENGINEERING Report,If Not ...Use Search to get more info about IRRIGATION ENGINEERING Report Or Ask Here

Options: